Landing into technical glitches in QuickBooks is pretty much common and thus, we have come up with this write up which is going to brief you with the right procedures to be performed to chuck off the QuickBooks error code 1327. Well, QuickBooks Error 1327 is basically an installation error that might be experienced at the time of installation of QuickBooks. It can also be seen when the drive recorded is unapproachable. You might happen upon the same error when the system is disconnected from a system drive or in case the portable storage device is removed. This error appears on the screen with a tiny warning message that says “The drive letter is invalid”.
Measures to be taken to rectify QuickBooks error code 1327
You can try coping up with QuickBooks install error 1327 by implementing any of the below measures.
Measure 1: Eliminating network drive
Initially, go for start tab and also select programs option
Choose windows explorer
Also, opt the network drive on which the shell folder is present
You are then supposed to click on ok tab
Moreover, choose map network drive in the tool menu
Shell folder uncheck reconnect at logon and write down the path.
Measure 2: Make a new windows user and install windows 10 or 7
Windows 7 or 8
You need to pick the start tab and click on control panel
Furthermore, opt for user accounts and choose manage another account
Make a new account
After assigning a name, choose admin
Go for create account and then reboot the system
Log in to the system with admin credentials
Install the software again
Windows 10
Opt for start tab and click on settings option
Click on accounts and choose family and other people
Select add someone else to this PC
Enter a new password, name, password hint, and also hit next tab.
Measure 3: Re allocate the drive letter
Windows NT
Choose start tab
Go for programs
Select admin tools and choose disk admin
Right click the drive and select assign drive letter
Choose the original drive letter.
Windows 2000
Go for start tab and choose settings option
Click on control panel and double tap admin tools
Double click on the system management
Right click the hard drive or CD ROM drive
Choose the path and change drive letter
Pick edit option and hit a click on original drive letter.
Measure 4: Configure registry settings
Under this process, you need to start the process by backing up the system registry
Press windows + R and type in regedit and click on run tab
Navigate to the specific key
HKEY_CURRENT_USER\Software\Microsoft\CurrentVersion\Explorer\Shell Folders
Look for entries that list the drive letter mentioned in the message
Configure the incorrect drive names to C:
Conclude the process by saving the settings and also reboot the system and try reinstalling
Once the installation process ends, revert the changes that were made to the registry earlier.